Do not use pure tungsten for HF Blister Packaging Machine

[Charlotte Leah]

When it comes to welding metal, you could make use of any Tarpaulin Welding Machine available
in the marketplace. Given the astronomical costly a TIG welder, you might be
tempted to opt for other welders as well. However, a TIG welder is by far the
most effective way for welding metal as it guarantees security, customer
friendly and high quality outcomes which are very important for developing
durable welds. Never compromise over high quality for cheap cost at any given
day and it is very important make durable welds, especially when you are
concerned in huge manufacturing. A TIG welder is a incredibly effective and
effective welding system for welding metal metal.

It is also very important set your TIG welding system with the right
parameters for ensuring excellent efficiency. The normal configurations for
welding metal are given below.

1. Set the current polarity to A/C configurations.

2. The ampere value should not be more than 1.5 amplifiers per 1/1000 inches
extensive of width of metal.

3. Set the amperage and contactor buttons to remote position.

4. Based upon the dimensions the cup, the flash light protecting gas should
be set to around 15cfh. If the cup is smaller than #7, set the protecting gas
value to be lesser than 15cfh.

Things you ought to watch out for while welding metal using a TIG welder:

1. Electrode gets hot at 250 amplifiers of A/C. Never use the same electrode
for DCEN.

2. Be sure to set the truly amazing regularity to continuous mode. The system
loses half cycles if this point is ignored.

3. Do not use pure tungsten for HF
Blister Packaging Machine .

[מאת]

תגובות